Sliced Walnut Hollow Form
About 7″ diameter x 4.5″ high. Walnut, turned green, sliced, and re-assembled with maple pewa. Finish is walnut oil.
There are a few small walnut pewa stitching a crack on one side (not shown in the picture).
Sliced Walnut Hollow Form
Walnut Hollow Form, about 6.5″ tall, 5″ diameter. Sliced and re-assembled with maple pewa. Walnut oil finish.
Cracked Hollow Form
Walnut, about 5″ diameter, 6 1/2″ tall. Maple pewa across the crack, turquoise fill in the crack.
Sliced Walnut Bowl
Walnut with Maple pewa over sawed gap. About 5″ diameter. Walnut oil finish.
Inspired by John Beaver’s work. This is an initial piece to explore some new (to me) ideas.
This piece was selected by the American Association of Woodturners Forum as Turning of the Week for April 11, 2022.
Walnut Hollow Form
This Hollow Form is Walnut, about 6-1/2″ around and 5″ tall.
Turned from a full log, so the pith (center of the log) runs thru the sides.
The stress around the pith usually leads to cracking. After it sat for a while and developed some cracks, I repaired them with Maple Pewa patches
There is a void in the side, where the tree grew around its own bark, likely due to some damage or a broken branch.
Walnut Hollow Form
This Hollow Form is Walnut, about 7″ around and 4″ tall.
It was turned from a full log, so the pith (center of the log) runs thru the sides of the form. There is a lot of stress around the pith, and it usually leads to cracking.
After it sat for a while, it did crack. I repaired those cracks with Pewa (butterfly) patches and Huini pegs, both made of Maple.
On one side of the form, there is a place where it appears a branch had broken off and the tree grew around it.
Small Walnut Calabashes
Some small walnut calabash bowls. the largest is 4″ x 3″, the small one is 2-1/2″ x 1-1/2″.
